Product Description
TE200A Eurotherm
TE200A Eurotherm
- Ergonomic design
- Analog input configured as voltage, current or potentiometer
- Burst firing or single cycle firing modes
- Input current 4-20mA
- Input voltage 0-5Vdc, 0-10Vdc
- Nominal current per phase 16-63A at 45°C
The TE200 range is designed for general purpose three phase applications which use three wire resistive or short wave infrared (SWIR) loads. Two of the three phases are switched by the TE200, the third phase being directly connected.
Control performance
The total power controlled in the three phase load (V²) is proportional to the setpoint. Linearity is better than +/- 2% full scale. Stability for +/- 10% supply voltage variation is better than +/- 2% of full scale.
Firing Mode
Single or burst firing with modulation period of 30 cycles at 50% power and 6 seconds at very high and low powers. Zero crossing firing with LED indication of status.
IDEAL FOR:
- Heat treatment
- Metallurgy
- Food processing
- Plastics
- Environmental temperature control
Ergonomic design
The TE200 range is easily integrated into a control system because of its compact size, simplicity of wiring and convenient DIN rail or bulkhead mounting.
TE200S Solid State Contactor
This unit is an ideal replacement for a mechanical contactor, accepting a DC or AC Logic input signal and giving two leg ON/OFF power switching.
TE200A Analogue input burst firing thyristor
The input to this unit can be configured for voltage, current or potentiometer inputs and the firing mode can be selected as burst firing or single cycle
